1. Three easy steps to fabricate the cards for the SudoHopper3D game

2. Interface of Grasshopper3D

3. Introduction to Parameters

4. What is a list?

5. Assignment 1: Create these lists of numbers with the Series and Range components

6. Assignment 2: Create two lists of numbers

7. Assignment 3: Draw few lines on the X axis

8. Assignment 4: Draw a square and scale in 2D a few times.

9. Assignment 5: Draw a rectangle with a diagonal line

10. Assignment 6: Copy and scale few rectangles

11. Assignment 7: Select only the closed curves

12. Assignment 8: Rotate and move a solid in the Z axis

13. Assignment 9: Create these two list of numbers

14. Assignment 10: Scale a rectangle from its original corner

15. Assignment 11: Draw random lines from a single point to different points

16. Assignment 12: Rotate a 2D cross section around an axis

17. Assignment 13: Polar array a square and scale each one of them

18. Assignment 14: Move, copy and rotate the rectangles along the X or Y axis

19. Assignment 15: Remap numbers

20. Assignment 16: Rectangular array of circles

21. Assignment 17: Draw circles with random radii

22. Assignment 18: Mass addition

23. Assignment 19: Select only the red circles

24. Assignment 20: Draw these arcs from these three lines

25. Assignment 21 Use the random reduce component to delete few rectangles

26. Assignment 22: Draw a few polygons from small to large in the Y direction

27. Assignment 23: Magnets

28. Assignment 24: Draw 9 or more circles on a flat surface

29. Assignment 25: Draw an ellipse and a circle. Then, divide both and connect the points with lines

30. Assignment 26 Wiring in between two circles to make a tower

31. Assignment 27: Draw curves tangent to the points on the curve

32. Assignment 28 Rectangular array of polygons with a random number of edges

33. Assignment 29: Scale circles along the X or Y axis with equal distances in between them

34. Assignment 30: Making a parametric ring

35. Assignment 31 Draw a pave (Honeycomb) of circles

36. Assignment 32 Draw a polyline at the end of all those points

37. Q & A Questions to the instructors, end of this course

38. Bonus package, six more exercises will be available 10 days after you enrolled

## 0 comments